Page History

...

• in case of code generator (the component name starts with "Config")
  You will get the following error, and it needs to select the interrupt setting in How to set the software conifugurable interrupt section:
  
• in case of FIT module (the component name starts with "r_")
  In general, the software configurable interrupt setting treats as automatically.
  It may not assign the vector table, so please check the behavior is wrong.
  Please check below sectioncheck Configure the "software configurable interrupt" In the Smart Configurator in this page.

How to set the software conifugurable interrupt

...

 
To resolve this error, you must configure additional interrupt settings in the "Interrupt tab".
As shown in the figure below, you need to select the interrupt from the corresponding interrupt vector group, INTA or INTB.
Please also refer to the "User Manual: Hardware" of each product to determine whether the interrupt belongs to INTA or INTB.
(see also the appendix of in this page)

How to check the software configurable interrupt is applied

...